12 / 16
51766 GB/2020-06
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
4 Application
4.1
Instructions for use
• Do not use any combustible, explosive, non-aqueous liquids or azeotropic mixtures directly
in the sound proof box (e.g. benzine, solvents). Combustible vapours can endanger the
operational safety of devices in the sound proof box, for example, the ultrasonic converter when
using the SONOPULS homogeniser, particularly if the ventilation system is switched o
ff
.
• When working with aggressive samples in the sound proof box: Prevent splashing on the
stainless steel surfaces or clean and dry the surfaces afterwards.
• When using preparations, the safety instructions in the respective product information must be
strictly followed.
• For processes that could result in splashing/leakage of liquids, always use the included drip tray
and perforated plate to prevent damage to the sound proof box.
4.2
General use
Open the door of the sound proof box completely.
Place the perforated plate on the bottom of the sound proof box and slide the drip tray below.
Position the noise source and required work materials in the sound proof box. Guide the
connection lines for the noise source through the rear opening in the body of the sound proof
box. Close the opening with the included sealing plug. If required, use the non-slip mat or
similar.
Close the door of the sound proof box.
Switch on the lighting and ventilation system using the push button. Check that the noise
source and work materials are easily viewed/monitored from outside.
Only now put the noise source into operation.
After work is complete, switch o
ff
the noise source.
Completely open the door of the sound proof box and remove the noise source or work
materials from the box.
Discharge the drip tray if required.
To prevent the accumulation of moisture, keep the lighting and ventilation system switched on
for approximately 5 more minutes with opened door.
Switch the sound proof box o
ff
using the push button.
