6 - 8 Fiveways Boulevard, Keysborough, VIC, Australia 3173
P: 1300 133 944 E: [email protected]
W: www.automatictechnology.com.au
Specifications
Battery Back up Specifications
Garage Door
Swing
Slider
Approximate number of Cycles under battery power
10
10
10
Average Cycle Time under battery power (Opening and Closing) 40 seconds
90 seconds
90 seconds
Wire Gauge and Length from Battery to Charger board (max)
18AWG, 3m
18AWG, 3m
18AWG, 3m
Battery capacity (Amp Hours)
2.3 AH
2.3 AH
2.3 AH
Time for Re-charge
24 - 48 Hours
24 - 48 Hours
24 - 48 Hours
Troubleshooting
Maintenance
To ensure a long trouble free life for your battery backup it is recommended you run the testing procedure on a monthly basis.
Batteries should not need replacing for 4 - 5 years.
Testing Procedure:
a. Press the transmitter to activate the opener.
b. Whilst the door / gate is in motion disconnect power. The door / gate should complete the cycle as normal.
c. Wait for the door / gate to finish is travel.
d. Press the transmitter to activate the opener.
e. Whilst the door / gate is in motion reconnect power. If the door / gate stopped or moved very slosly under battery power,
ensure mains power is connected for 24 - 48 hours to recharge the batteries. Test the opener again under battery power in
72 hours to ensure batteries are working effectively.
Symptom
Possible cause
Remedy
Door stops or moves very slowly
under battery power
Batteries may be weak or have
no charge
Connect mains power and allow the batteries
to charge. This may take 24 - 48 hours to reach
maximum charge capacity.
Door will not operate when
mains power is disconnected.
Batteries / charger board may
not be connected properly.
Check wiring.
Batteries may have no charge
Connect mains power and allow the batteries
to charge. This may take 24 - 48 hours to reach
maximum charge capacity.
Faulty Charger board
Disconnect the charger board from batteries and
control board. Check voltage of the charger board.
Voltage should be approximately 27.5V.
Faulty Batteries
Disconnect the batteries from the charger board.
Check the voltage of the each battery. Voltage
should not drop below 10V.
