6 - 8 Fiveways Boulevard, Keysborough, VIC, Australia 3173
P: 1300 133 944 E: [email protected]
W: www.automatictechnology.com.au
Swing Gate Opener Set Up
DCB-05
Mount the Charger Board
a. Unplug the Control Box from mains power.
b. Remove the Control Box’s cover.
c. Secure the adhesive mounts
21
to the Charger Board with cable ties
22
. Affix the Charger Board
20
inside the the Control Box cover.
d. Plug the Charger Board’s four (4) wire harness (red/yellow/white/black) into the DCB-05 board’s “SBY-03” connector.
WARNING!
The opener will become active
during the following steps.
Mount & Connect the Battery
a. Drill a hole in the Battery Pack enclosure (recommend at the bottom) and fit a nylon gland (not supplied).
b. Mount the Battery Pack
19
using the mounting brackets
23
and screws
24
close to the opener.
c. Feed a 2-core 18awg gauge cable (not supplied) through the Battery Box’s nylon gland.
d. Connect the
red wire
to the Battery Box’s “+” terminal, and the
black wire
to the “–” terminal
e. Feed the other end of the 2-core 18awg gauge cable through the control box’s gland.
f. Connect the
red wire
to the Charger Board’s Battery Harness“BAT+” connector, and the
black wire
to the “–BAT” connector.
Re-setup and Test the Opener
a. Reconnect power.
b. Select Menu 7 on the DCB-05 control board, press “SET”, select Sub Menu 7 (“Battery/Solar”) and enable using the “OPEN” and
CLOSE” buttons.
c. Setup travel limits and transmitters as per the DCB-05 instruction manual.
d. Press either “OPEN” or “CLOSE” buttons, or use a transmitter to operate the gate.
e. Whilst the gate is in motion, disconnect mains power. The gate should continue to operate as normal.
NOTE:
Wait for the gate to complete its travel.
f. Press the transmitter to activate the gate. Whilst the gate is in motion re-connect power. The gate should complete the cycle as
normal.
g. Refit the control box cover.
WARNING!
Do not connect the batteries until
you have connected wiring on the charger
board.
23
24
19
9
8
22
20
1
21
