prior to installation
Preparation - setting the door limits
Ensure the door limits have been set on the opener,
prior to installing the Auto-lock. Refer to the opener
manual for instructions.
install batteries
a. Insert batteries
4
into drive unit.
b. Place cover back on drive unit
and secure with 4 x screws
3
.
4
3
WARNING! remove all manual locking
systems prior to installing lock. Any damage
as a result of a manual lock will void the
warranty for the door, Auto-lock and opener.
program lock
a. Press and hold the info button
i
on drive
unit until the light goes red.
b. Then press the lock/unlock button to test
the drive unit.
MINIMUM SIDEROOM REQUIRED FROM INSIDE GUIDE TO
EDGE OF BRACKET/AUTO-LOCK
INSTALLATION
STANDARD
(side mount)
LIMITED SIDE ROOM
(front mount)
R1N
135mm
90mm
Limited Sideroom installs (only)
a. Before the guides are installed on the door,
place the lock striker
7
into the second
bottom curtain corrugation, pushing
striker towards the door edge, whilst sliding
the legs under the Nylofelt
®
and hooking
them over the curtain edge, before
snapping into position as per diagram.
b. Repeat for second lock striker at other
side of door.
c. Continue with door installation before
proceeding.
install striker & corrugated plate
7
W
Install Corrugated plate
a. Unscrew the bottom rail stop on each side of the door.
b. Cut the bracing bar
13
to the length of bottom rail and
pre-drill hole at each end for bottom rail stop.
c. Fit angle steel clips
12
at each end, before refitting bottom rail
stop.
d. Measure the middle point of the door at the first corrugation.
Place corrugated plate
9
at middle point and mark position
of edges on door.
e. Use Alcohol wipe
10
to clean surface where plate is to be fitted.
f. Remove tape from corrugated plate and place on door.
g. Take the weight bar
W
, nuts and screws from the opener box
and install as shown.
9
mark position &
clean with wipe
10
12
12
13
2
Auto-Lock Kit -
R1N Installation instructions
