![background image](http://html.mh-extra.com/html/bandd/controll-a-door-p-diamond-sdo-2v2/controll-a-door-p-diamond-sdo-2v2_instruction-manual_460066007.webp)
Operating Controls
01.
Terminal Block.
V+
is used to power devices such as Wireless Safety Beam, external receiver etc.
EB1
input is used to connect to Safety Beam.
0V
(Input) is a 0 volt connection for Safety Beam, external receiver, osc, aux etc.
EB2
input is used to connect to second Safety Beam..
0V
(Input) is a 0 volt connection for Safety Beam, external receiver, osc, aux etc.
O/S/C
is used for the connection of a wired switch (momentary contact). This switch can then be used to open, stop
or close the door. Install the wall switch in a location where the switch is out of reach of children and the garage door
is visible.
AUX
This function allows the opener to operate an alarm system via the garage door remote control.
OPERATE button (Blue)
is used during installation to test the open, stop and close cycles for the opener. The opener
has to be initialised by the LIMIT SET button to make the OPERATE button operable.
SERVICE LED (Yellow)
indicates when the opener requires service or repairs.
LIMIT SET button (Blue)
is used during installation, together with the PLUS (+) and MINUS (-) buttons, to set the door
limit positions.
FORCE MARGIN SET button
. The obstruction force margin is set automatically during installation. The margin can
be adjusted manually using the FORCE MARGIN SET button (White). Holding the FORCE MARGIN SET button and
pressing PLUS (+) or MINUS (-) buttons will increase or decrease the amount of force. The FORCE MARGIN SET button
should only be used if environmental factors, such as high winds, affect the door’s operation.
CODE SET LED (Red)
fl
ashes when a transmitter button is stored.
MINUS (-) button (Red)
is used during installation to set the close limit position. Pressing and holding this button will
move the door in the close direction. Movement stops when the button is released. This button is also used for storing
or erasing the transmitter button you wish to use to command the door to open, stop or close.
NOTE: The safety obstruction system is inoperable whenever the MINUS (-) button is used to move the door.
CLOSE LIMIT LED (Red)
is used during installation to help set the close limit position. It also illuminates and
fl
ashes as
the door closes, and remains on when the close limit position has been reached.
PLUS (+) button (Green)
is used during installation to help set the open limit position. Pressing and holding this button
will move the door in the open direction. Movement stops when the button is released.
NOTE: The safety obstruction system is inoperable whenever the PLUS (+) button is used to move the door.
OPEN LIMIT LED (Green)
is used during installation to help set the open limit position. It also illuminates and
fl
ashes
as the door opens, and remains on when the open limit position has been reached.
AUTO CLOSE JUMPER
fi
t the shunt on both pins to enable Safety Beam triggered auto close
PROG INPUT
is used to connect the Automatic Technology Handheld Programmer ‘PG-3’ for editing control and
receiver functions, accessing diagnostic tools, and activating special features and operating modes.
SBCO-2 Battery Charger connector
to attach a Battery Back Up kit.
10 Amp fuse
to protect the electronic circuit board.
02.
03.
04.
05.
06.
07.
08.
09.
10.
11.
13.
14.
12.
Diamond PD Power Drive : Instruction Manual
© Copyright 2012 B&D Doors
7
Controll-A-Door
®
P
Diamond SDO-2v2
Instruction Manual
Summary of Contents for Controll-A-Door P Diamond SDO-2v2
Page 37: ......