![background image](http://html.mh-extra.com/html/bandd/controll-a-door-p-diamond-sdo-2v2/controll-a-door-p-diamond-sdo-2v2_instruction-manual_460066013.webp)
Centre of door
Step
Ladder
Step
Ladder
C rail
Door
Highest point
of door travel
Fig. 16
Fig. 15
Fig. 14
Fig. 17
Mounting on a Non-Track Type Door
WARNING: Make sure concrete, brick wall
or timber lintels are solid and sound so as to
form a secure mounting platform.
Step 8 - Determine the Door’s Centre
a. Find the centre of the door and mark this location both
above the door and on top of the door.
b. Draw two lines 21.5mm either side of this
(Fig. 14).
Step 9 - Prepositioning the Opener
a. Raise the door to open position.
b. Rest the opener on the top edge of the door with end
of the C-Rail against the wall
(Fig. 15)
.
c. Support the powerhead level with the lowest point of
the open door
(Fig. 15)
.
NOTE:
Do not slide C-Rail along the face of the door.
Step 10 - Mounting the C-Rail
a. Close the door slowly. The C-Rail will be elevated by
the top edge of the door as it moves.
b. Stop the door when it is at its highest point of travel.
Allow 25mm additional height for clearance between
the door and the track
(Fig. 16)
.
c. Support the C-Rail in this position and close the door
d. The height determined in Step 11(b) will be the height
at which to mount the wall bracket.
e. Centre the bracket along the line determined in Step 9.
f. Using the bracket as a template, mark a minimum
of two holes and drill with appropriate size bit. For a
more secure
fi
tting, the wall bracket can be anchored
using more than two holes.
g. Secure the bracket to the wall using:
IF CONCRETE OR BRICK - 8mm or 5/6 loxins or
dynabolts.
IF TIMBER - wood screw #20 or equivalent
(minimum 50mm long).
h. Attach the wall bracket to the C-Rail with the 90mm
long clevis pin
(Fig. 17)
and secure by a snap pin.
Step 11 - Securing the Powerhead to the Ceiling
a. Secure the perforated angle (not supplied) to the
ceiling above where powerhead’s mounting holes will
be. See
(Fig.13)
for a representative mounting.
b. Connect the powerhead to the ceiling mounted
perforated angle with M8x20mm screws and nuts.
Strips should not extend more than 18mm below
centre of powerhead mounting holes
(Fig. 13)
.
WARNING: The opener must be securely
fastened to structural supports, otherwise
opener failure may ensue causing serious
personal injury and/or property damage.
Diamond PD Power Drive : Instruction Manual
© Copyright 2012 B&D Doors
13
Controll-A-Door
®
P
Diamond SDO-2v2
Instruction Manual
Summary of Contents for Controll-A-Door P Diamond SDO-2v2
Page 37: ......