Product Introduction
10
Manual Documentation Number: ZXTx-IO-x-0712m
2.5.1 Radio Signal Strength Indicator (RSSI) LEDs
The
Signal Strength
LEDs provide an indication of the signal strength of the received radio signal. 8 Green LEDs in a bar
graph format show the signal strength from Weak to Strong. The table below explains the RSSI LEDs:
LEDs Number
turned ON
Signal Strength
0
No signal
1-3
Weak
4-6
OK
7-8
Strong
Figure 2-7
RSSI LED Status Table
2.5.2 Mode LEDs
The I/O module operates in one of the following 3 modes and its status is shown by the corresponding green LEDs:
-
Modbus
-
Peer-to-Peer Master
-
Peer-to-Peer Slave
2.5.3 Wireless LED
This LED will flash whenever wireless data is transmitted or received.
2.5.4 Power LED
1) A green status LED indicates that an adequate dc power is available to the module.
2) This LED will flash on Comm. Fail.
2.5.5 I/O Status LEDs
Green status LEDs show the status of the digital inputs and relay outputs in the I/O module
2.5.6 Configuration Pushbutton
The Configuration Button allows the user to select one of the following I/O operation modes without the need for a PC:
-
Modbus
-
Peer-to-Peer Master
-
Peer-to-Peer Slave.
Follow the steps below to change the I/O module configuration mode using the Configuration Push Button.
1) Press and HOLD the PB until all MODE LED's flash.
2) A single LED will begin to flash, which depends on the mode the device is currently in. An example would be the P2P
Master LED will flash, if the device was in P2P Master mode.
3) Pressing the Config PB will increment through the other modes; P2P Slave, Modbus, etc.
4) If the Push Button is not pressed for 4 sec, the device will exit and select the mode that was indicated by the flashing LED.
Summary of Contents for ZXT24-IO-222R2
Page 6: ......
