IT1000-C / IT2000-C
1/4” IT
Tool
www.BAND-IT-IDEX.com
Document # P49050 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Page 21 of 36
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
At a minimum BAND-IT recommends that the tool be connected to a weight balancer
or be mounted in a fixture that will provide adequate rotation during operation.
Fixture Hanger
Weight
Balancer
IT Tool
Swing Arm
•
Support boom & Balancer
• 4 axis of movement
to locate tool directly
over target clamp
location.
• The balancer must
support a tool weight
of approximately 5 lb.
The tool comes with a hanger loop installed on the top face to mount to a weight balancer.
When removed, there are four M5 threads that can be used to secure the tool to a fixture. The
included tool hanger may be attached to any of the mounting holes as shown below.
Caution:
do not allow screws to extend deeper than 7/16” (0.438”) into the tool
body. Longer screws will interfere with the internal components of the tool and
cause tool to jam.
