A351, A355
PNEUMATIC TOOL
www.BAND-IT-IDEX.com
Document # P35087 Rev. I
© Copyright
BAND-IT-IDEX, Inc. 2021
All rights reserved
Page 11 of 19
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
A35599 Micro Pneumatic Tool
1.
Be sure to read tool instructions(Page 4 to 9) and safety guides (page 3) before using
tool.
2.
Tool is factory calibrated to 80 ±5 lbs tension. (REF. ~ 23 psi on air pressure gage).
For accurate tension setting, calibration device must be used (part number: E1000).
For calibration procedure see Page 16& 17. Calibration with device will ensure proper
tension setting.
3.
A35599 pneumatic tool used only on 0.120” wide BAND-IT Tie-Dex Micro Bands.
4.
Condition of locking lip should be visually inspected on completed clamps. If lip
appears partially torn, damaged or not present at all, check tool tension and condition
of blade and knife. Make necessary adjustments and repairs. Be sure to remove and
replace faulty clamps.
Warning:
For A35599 tool, adjusting tension above 90 lbf may damage tool or tie (or both).
Fig. 7
Refer to website for warranty information
:
http://www.band-it-idex.com/warranty.html
US Patent Number:
11034472