TRIMMER “FOR” - MOTOR SPEED
Trimmer “FOR” adjusts the voltage applied to the motors during operations, which means adjusting
the speed of the motors. With the trimmer turned fully counter-clockwise the speed of the motor if
50% of the maximum speed.
With the trimmer at half travel the speed of the motor if 50% of the maximum speed.
ATTENZION: Changing the setting of trimmer “FOR” requires repeating the learning procedure, since
the travel times and the slow-down start times change.
6. TRIMMERS AND ADJUSTMENTS
TRIMMER “PAU” - PAUSE TIME
Switch the dip-switch 6 to OFF and the dip-switch 7 to ON.
Set the “PAU” trimmer in an intermediate position according to the pause time desired. The pause
time can be set between 3 and 60 seconds and is increased by rotating the trimmer clockwise.
TRIMMER “OBS” - OBSTACLE SENSITIVITY DETECTION
The “OBS” TRIMMER is used to adjust at the same time the delay time of intervention after an
obstacle has been detected and the threshold of the counter-force against the operator necessary to
trigger the intervention. Both the counter-force and the delay time increase when the trimmer is
turned clockwise. The delay time can be adjusted between 0.1 and 3 seconds. This function is useful
to overcome any critical points of the operator which cause a higher power absorption by the motor
for a short time..
11