1. Fix the first element of the arm between the two arm supports tightening
2. Loosen the screws of the arm support and let the arm slide down on the floor
WARNING: NEVER REMOVE THE ARM IN HORIZONTAL
Safety screw
5. Release the arm and make sure that the arm does not go up by itself
POSITION WITH THE SPRING UNDER TENSION
9
ARM D.70 mm
4,8 x 16
NUTS M8
6. Add other pieces of the arm as shown in the following page
7. Unlock the motor and check if the arm movement is uniform
3. Remove the arm support keeping the arm in vertical position
DANGER OF FATAL INJURIES
1. Move the arm in the opening position and lock the motor
ARM SUPPORT
Arm fixing
8. Adjust the spring tension (pag.11)
SCREWS
M8x16
4. Put the arm on the floor carefully
the
screws and the
self-locking nuts
M8x16
M8
2. Unlock the motor (page 5)
3. Put down the arm carefully
Arm removal
4. Lock the motor
BARRIER
OPERATING FIELD OF
BAME
,
THE WEIGHT SCHEME
IT IS ADVISED TO USE
ORIGINAL PROFILES.
NEVER ENTER THE
THE ARM DURING
OR NORMAL USE.
PLEASE CONSIDER
AS SHOWN IN THE
FOLLOWING PAGE.
INSTALLATION
DIFFERENT ARM
FROM THE ONE
YS
BAME
SUPPLIED BY
WARNING:
IF USING A
A
LW
A
FIG.8