BALZER Field Floater 1325 Extension, User Manual

Page: 76 / 83

This will temporally bypass the safety device to prevent
folding swivel auger when auger is not rotated correctly.
Troubleshooting
Make sure that swivel auger clears grain cart body as
auger is folded down.
6) Vertical upper auger will not fold down.
A) Unplug the weather pack wire connection from valve body solenoid that controls the clutch. (Marked
#3)
B) Unplug the weather pack wire connection from the solenoid valve that controls the upper auger
folding cylinder. (
C) Plug the wire from the valve body solenoid that controls the clutch (Marked #3) into the wire from
the solenoid valve that controls the upper auger folding cylinder.(Female Wire
D) Rotate swivel auger so it is straight up and down.
Marked #9)
Marked #3)
E) Push and hold trigger to run clutch. This will lower vertical upper auger down to the saddle.
F) Now re-adjust magnetic limit switch till RED light on the joystick turns on.
G) Reconnect the wires.(Wires
H) If auger still will not fold up or down, call Balzer's Service Department at 1-800-795-8551 extension
134 or 0 for the operator.
Marked #3 and #9)
7) When unfolding vertical upper auger to unload, it is slamming down hard.
A) Unfold vertical upper auger all the way.
B) There is a bleeder screw on the vertical upper auger on the rod end of the cylinder. Crack open the
screw just a little to let the air bubbles out.
C) Close bleed screw tightly.
D) You might have to fold and unfold vertical upper auger a couple of times to push all the air out.
E) If auger is still slamming down hard, call Balzer's Service Department at 1-800-795-8551 extension
134 or 0 for the operator.
8) Joystick will not work.
A) Check and make sure that you have a minimum of 11 volts at all times.
Some tractors with a lot of electrical devices turned on at the same time
may run a little low on voltage. Try turning off un-needed devices to
obtain the minimum voltage level.
B) If joystick is still not working, call Balzer's Service Department at 1-800-795-8551 extension 134 or 0
for the operator.
NOTE
BALZER
INC.
76