baltur TBL 1000 ME, Instruction Manual For Installation, Use And Maintenance

Page: 56 / 72

FLOW REGULATOR
The flow regulator allows obtaining the desired pressure adjusting the
fuel flow rate by means of the adjustment indicator present on both
sides.
The adjustment is obtained through a shutter inside the unit, that modi -
fies the passage section according to the shaft rotation.
Each regulator model is defined by the diameter of the passage section
(see graphs).
CAUTION / WARNINGS
Do not use any kind of threadlocker.
OPERATION
Shaft rotation controls the fuel flow through a regulator and varies from
the indicated “-” to “+”.
The flow that runs through it depends on the pressure difference
between its inlet and outlet.
MAINTENANCE
Following a continuous use, the shaft may wear out and cause seeping
of fuel in case of minimum operating conditions.
The required maintenance intervention is the replacement of the snap
rings.
IMPORTANT
Any damage depends on the fuel quality.
To remove the snap ring present inside the flange:
• remove the indicator fastened by the screw;
remove the snap rings from the seat.
CAUTION / WARNINGS
Before refitting the components check that they are in good con -
ditions and clean.
The position of the regulation index has been set by the manufacturer,
both the ends of the regulator have a seat for the correct positioning
of the indicator.
1
2
3
O
0005080076
I
I Liquid fuel inlet
O Liquid fuel outlet
1 Regulation index
2 Liquid fuel flow regulation flange
3 Flow regulator body
4
4
5
5
I
O
0005080076_01
I Liquid fuel inlet
O Liquid fuel outlet
4 O-ring 17.17 x 1.78
5 O-ring 7.66 x 1.78
20 / 34
0006160393_202104
ENGLISH