baltur TBG 80 LX PN V, Manual User Instructions

Page: 9 / 160

0002934670
0002934740
0002934730
0002934720
7 / 26
0006081537_201311
ENGLISH
CONNECTING THE BURNER TO THE BOILER
assemBLing tHe HeaD unit
• Adjust the position of the coupling flange 5 by loosening the screws
6 so that the combustion head penetrates into the furnace to the
extent recommended by the generator manufacturer. Referring to
the diagram at the side, fit the rigid pipe in the housing provided on
the connection flange and fasten it with the screw. This pipe will be
cut flush with the diffuser.
• Position the insulating gasket 3 on the sleeve inserting cord 2
between flange and gasket.
• Fasten the head unit 4 to the boiler 1 by means of the stud bolts,
washers and the nuts provided 7.
!
Completely seal the gap between the burner sleeve and the
hole in the refractory material inside the boiler door with
suitable material.
assemBLing tHe gas train
There are different ways of assembling the valve train, 8, 8a and 9 as
shown in the drawing. Choose the most rational position for the set-up
of the boiler room and the position in which the gas pipeline arrives.
!
in case of very large valves, e.g. Dn65 or Dn80, make sure
there is a suitable support to prevent excessive stress on
the gas train fitting.
assemBLing tHe VentiLating unit
• Position the half-hinge on the burner scroll in line with those on
the head unit.
• Insert the hinge pin 10 in the position considered most suitable.
• Connect the cables (ignition and ionisation) to the corresponding
electrodes. Close the hinge, locking the burner by means of screws
11.
Rigid pipe fixing screw
Rigid pressure detection pipe in the combustion
chamber
Pressure intake
in the combustion
chamber
Cut flush with diffuser
Pressure transmission pipe
in the combustion chamber