BURNER CONNECTION TO THE BOILER
HEAD UNIT ASSEMBLY
The combustion head is packaged separately from the body of the
burner.
Anchor the head unit to the boiler door as follows:
•
Adjust the position of the coupling flange (19) by loosening the
screws (6) so that the burner head enters the furnace to the extent
recommended by the generator manufacturer.
•
Position the insulating gasket (13) on the sleeve, by inserting the
cord (2) between the flange and the gasket.
•
Fasten the head unit to the boiler(1) by means of the stud bolts,
washers and the nuts provided (7).
DANGER / ATTENTION
Seal the space between the burner sleeve and the hold on the
refractory material inside the boiler door completely with suitable
material.
ASSEMBLING THE GAS TRAIN
The EN 676 approved gas train is sold separately from the burner.
The gas train can be assembled in different ways: (1), (2), (3).
Choose the most rational position for the set-up of the boiler room and
the position in which the gas pipeline arrives.
DANGER / ATTENTION
In case of very large valves, e.g. DN65 or DN80, make sure
there is a suitable support to prevent excessive stress on the
gas train fitting.
ASSEMBLY OF VENTILATION SYSTEM
For burner handling, use certified chains or ropes suitable for the
burner weight using the anchoring points (21).
For a correct installation of the ventilating body, follow the procedure
described below:
Position the half-hinge on the burner scroll in line with those on the
combustion head assembly.
•
Insert the hinge pin (10) in the position considered most suitable
•
Connect the ignition cable to the relevant electrode, close the hinge
by fastening the burner with the screws (11).
Use the specific chains or ropes connected to the respective anchoring
points (21) of the burner.
ACOUSTIC SHROUD
If it is necessary to reduce the sound pressure level, install a suitable
acoustic shroud. (see technical price list and contact the dealer) ).
1
2
13
0002934720
19
7
6
1
3
2
0002934960
11
21
21
10
0002934970
13 / 34
0006081328_202202
ENGLISH
Summary of Contents for TBG 80 LX ME
