baltur BTL 3, User Instruction Manual

Page: 46 / 56

MALFUNCTION CAUSE DIAGNOSTICS AND LOCK
In the event of a burner lock-out, the red light on the reset button will be fixed.
Keeping it pressed in for more than 3 seconds, the diagnostics procedure is activated (red light with quick flashes). The table below indi -
cates the meaning of the lock-out or failure according to the number of red flashes.
Holding the reset button down for at least 3 seconds, the diagnostics function will be interrupted (for further details see technical sheet
7614).
The diagram below indicates the operations that are necessary to activate diagnostics functions.
EK
> 3 s
Flashing
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
EK
> 3 s
O
CI
40
0
EK
< 3 s
71
30
z04e
/060
2
Reset
On
Operating position
PC interface/
diagnostic analyser
Colour code table
Diagnostics
Operating position Operating position
Visual indication AL to terminal
10
Possible causes
2 blinks
●●
On No flame at the end of the safe ignition time<TSA>
- Faulty or soiled fuel valves
- Faulty or soiled flame detector
- Poor adjustment of burner, no fuel
- No ignition Faulty ignition transformer
3 blinks
●●●
On Available
4 blinks
●●●●
On Extraneous light during the ignition phase
5 blinks
●●●●●
On Available
6 blinks
●●●●●●
On Available
7 blinks
●●●●●●●
On Lack of flame signal during normal operation, ignition repeated (ignition is repeated
max. 3 times)
- Fuel valves' failure or earthing not correct
- Poor adjustment of burner
8 blinks
●●●●●●●●
On Fuel preheating time failure
9 blinks
●●●●●●●●●
On Available
10 blinks
●●●●●●●●●●
On Wiring problems or damage inside the device
• Under fault conditions the device remains deactivated. The burner is off.
• The «AL» alarm signal is on terminal 10 that is under voltage. To reactivate the device and start a new cycle, press the reset button for
1 sec. (< 3 sec).
ENGLISH
18 / 26
0006080735_201409