baltur BGN 200 LX, Maintenance, Use And Installation Manual

Page: 22 / 53

14 / 36
0006081062_200
904
E
N
G
L
I
S
H
COMBUSTION HEAD ASSEMBLY
Following the drawing, connect the tube on the attachment on the
flange and fix with the screw
To put in place insulation flange 2, which must be positioned
between the burner and the plate of boiler 1, the end of the com
-
bustion head must first be removed.
a) Adjust position of connector flange 4 by loosening screws 6
so that the combustion head penetrates into the combustion
chamber the amount recommended by the generator’s manu -
facturer.
b) Position seal insulation 3 on the tube unit.
c) Fasten the combustion head assembly to the boiler 1 using the
stud bolts, washers and the nuts provided 5.
d) With suitable material, completely seal the space between the
tube unit of the burner and the hole on the refractory plate inside
the boiler door.
0002934880
Pressure transmission pipe in
combustion chamber
Burner flange
Pressure detection pipe connection
nipple in combustion chamber
Pressure take-off in
combustion chambe
CHAMBER FOR MODEL BGN 540 LX
FOR MODELS BGN 200 LX÷BGN390 LX
N° 0002934900
Pressure detection pipe
connection nipple in combustion
chambe
Rigid pipe
fastening
screws
00029333821
Cut pipe flush with
diffusor
Pressure take-
off in
combustion
chamber
Plate and refractory
wall hole to be
drilled to Ø 12
MEASURING THE PRESSURE IN THE COMBU-
STION CHAMBER
If the hole in the door is too small to allow the hose to pass and the
door has no flame inspection window it will be necessary to make
a Ø 12 in order to install the pressure take-up hose (supplied with
the burners), whose position is shown in the flange drilling-plate
drawning
s n° 0002471100 - 0002933821.
1 Boiler plate
2 Flange with insulating materials
3 Seam with insulating materials
4 Burner securing flange
5 Stud bolts, washers and nuts for fastening to the boiler
6 Nuts screws and washers to fasten flange to the sleeve
Rigid pipe that reads
combustion chamber
pressure