CORNER REPLA V COUNTER
ADJUSTMENTS
Tapered
Shim
Stop
Plate
Stop Plate is Fastened
down by screws after Stop
Plate is held in fartherest
upward position with inser
ted Shim Gauge as shown.
adjustment screw
H
See Note #1
Pre-Adjustment
Must rest into each Tooth
on each step without
binding.
All moving parts
must be greased.
All
moving parts
must be greased
SEE NOTE
STAR
REPLAY
COUNTER
All Cam and Ratchet
Edge Surfaces and
Center Shaft Surfaces
must be greased.
See Note #3 for
Step Adjustment
Note #1: Magnet Assembly Pre-Adjustment
(1) Loosed Lock Nut (A)
(2) Loosen Lock Screw (B)
(3) Loosen Adjustment Screw (C)
(4) While holding the Armature Assy. down to the
Coil (D), place the .110 Gauge (E) between the
Adjustment Screw (C), and the Armature Assy.
as shown at (F) (Screw must clear weights).
(5) Tighten down the Screw (C) until the Gauge (E)
cannot be removed (do not force).
(6) Loosen the Screw (C) slowly until the Gauge (E)
may be removed (F) with the feel of rubbing of
both the Armature and the Adjustment Screw (C)
when removed
(7) Tighten Lock Nut (A)
(8) Remove the Gauge (E) and recheck the adjustments
Note: Adjustments may be altered slightly for the
Adjustment of the Pawl into the Teeth of the
Ratchet (G)
CONTINUED
ALWAYS GIVE MOOEL ANO PART NO. WHEN ORDERING SERVICE PARTS
40