Balluff MICROPULSE BTL7-A/E1 0-M Series, Manual, Page: 38 / 120

14 english
6
Calibration procedure (continued)
6.3.2 Adjusting
The detailed procedure for adjusting is
described on page 16 ff.
The factory set null point and end point is replaced by a
new start point and end point and the associated output
values can be adjusted. The start and end values can be
adjusted as you like up to the limits.
Steps
►
Move magnet to the new start position.
►
Read new start point by pressing the buttons.
► Set the new start value by pressing the buttons.
New null point
Before
After
Fig. 6-4: Adjust a new start value
► Move magnet to the new end position.
►
Read new end point by pressing the buttons.
►
Set the new end value by pressing the buttons.
New end point
Before
After
Fig. 6-5: Adjust a new end value
6.3.3 Reset
Restoring the transducer to its factory settings.
The detailed procedure for the reset is
described on page 18.
New start value
New end value
BTL7-A/E1 _ 0-M _ _ _ _ -K(8)-SA262-K _ _ /F _ _
Micropulse Transducer - Rod Style