25
BVS Cockpit
PROFINET
LED
Indicator
Function
Fieldbus 1
MS: Bus Failure
Off
No fault or no voltage
Red flashing
No data exchange or no configuration
Red on
PROFINET IO not configured or not connected
Fieldbus 2
NS: System Failure
Off
No fault or no voltage
Red on
PROFINET IO not ready
Fieldbus 1 and Fieldbus 2
Both LEDs flashing red
DCP signal service enabled
EtherNet/IP
LED
Indicator
Function
Fieldbus 1
NS: Network Status
Off
No voltage or no IP address
Green
Connection made
Green flashing
No connection made
Red
Duplicate IP address
Red flashing
Connection timeout
Red - Green flashing
Self-test after switch-on
Fieldbus 2
MS: Module Status
Off
No voltage
Green
Device is ready for operation
Green flashing
Device not configured
Red
Severe, fatal error
Red flashing
Simple, rectifiable error
Red - Green flashing
Self-test after switch-on
IO-Link
LED
Indicator
Function
IO-Link
C/Q
Off
Status of input or output pin is 0
Green on
IO-Link communication active
Flashing green (1
Hz)
No IO-Link communication or wrong IO-Link device
Flashing green rap-
idly
IO-Link preoperate during data retention
Yellow on
Status of input or output pin is 1
Flashing red rapidly
Validation failed / incorrect configuration of the IO-Link data length / self-test
after switch-on
Rot on
IO-Link short circuit / sensor supply short circuit / firmware update
IO-Link Pin
2
Off
Status of input or output pin is 0
Yellow on
Status of input or output pin is 1
Red on
Short circuit at output
LAN
LED
Indicator
Function
LAN Link
Off
No LAN connection
Green on
LAN connection established
LAN Act
Off
No data transfer
Yellow flashing
Data transmission
3.6 Cleaning
The outside of the camera can be cleaned with a soft cloth. Persistent dirt can be removed with a cloth that is first mois-
tened with a soap solution and wrung out.
→ After wiping off the dirt spots, wipe the camera with a dry cloth.
Summary of Contents for BVS SC-C1280Z00-30-000
Page 1: ...BVS SC _1280Z00 30 0 0 SMARTCAMERA Fieldbus...
Page 2: ......
