Balluff BNI PNT-502-105-Z015, User Manual

Page: 7 / 20

www.balluff.com
6
3 Getting Started
3.2. Mechanical
connection
The module is attached using 2 M6 screws and 2 washers.
Isolation pad as accessory available
3.3. Electrical
connection
Power Supply
Power supply “IN” (7/8”, male)
Pin Function Description
1 GND actuator power supply 0 V
2 GND Bus- / Sensor power supply 0 V
3 Grounding FE
4 Bus- / Sensor power supply +24 V
5 Actuator power supply +24 V
Power supply
“OUT” (7/8” female)
Pin Function Description
1 GND actuator power supply 0 V
2 GND Bus- / Sensor power supply 0 V
3 Grounding FE
4 Bus- / Sensor power supply +24 V
5 Actuator power supply +24 V
Note
Provide sensor/bus power and actuator power from separate power sources if
possible.
Total current <9A per Pin. The total current of all modules may not exceed 9A
even when daisy chaining the actuator supply.
Grounding
Note!
The FE connection from the housing to the machine must be low-impedance
and kept as short as possible.
PROFINET
Interface M12, D-coded, female
Pin Function
1 Tx+
2 Rx+
3 Tx-
4 Rx-
Note!
Unused I/O port socket must be fitted with cover caps to ensure IP67 protection
rating.