Balluff Network Interface
EtherNet/IP™, BNI EIP-50x-105-R015
www.balluff.com
6
3
First Steps
3.2.
Mechanical Con-
nection
The module is secured by means of two M6 screws and two washers.
Insulation support is available separately.
3.3.
Electrical Con-
nection
Power Supply
IN
7/8”, male
OUT
7/8” female
Pin
Function
Description
1
+24 V
Actuator supply
2
+24 V
Module / sensor supply
3
0 V
GND module / sensor supply
4
0 V
GND actuator supply
Note
Where possible, use a separate power source to supply the sensor/bus and
actuator with power.
Total current < 9 A The total current of all modules must not exceed 9 A even in
the case of series connection of the actuator supply.
Grounding
Note!
The functional ground connection between housing and machine must have a
low impedance and be as short as possible.
Ethernet IP Inter-
face
M12, D-coded, female
Pin
Function
1
Tx+
2
Rx+
3
Tx-
4
Rx-
