Ballu BOGH-15, Operation Manual, Page: 6 / 24

6
4. Safety Instructions
• Carefully read the instructions
before use. Familiarize yourself
with the device and methods
of controlling an infrared gas
heater.
• Follow the maintenance
instructions and fault table
described in this manual.
• Do not block the inlet and outlet
of the infrared gas heater.
• Do not block the ventilation
openings of the compartment
where the gas cylinder is located.
• Do not use infrared gas heaters
in basements and other areas
below ground level.
• In the room where the infrared
gas heater works, there must
be constant ventilation in
accordance with the technical
specifications.
• The size of the room should
not be less than specified in the
technical specifications.
• The infrared gas heater should
not be used in the immediate
vicinity of explosive substances.
• Do not heat gas cylinders, even
if the cylinder is “frozen”.
• Installation, transportation and
storage of gas cylinders should
be carried out in accordance
with the rules, regulations and
instructions for safe operation
adopted in your area.
• The product must be repaired
only by a qualified, authorized
service center worker.
• To ensure safety, always turn
off the gas cylinder before
disassembling an infrared gas
heater, for maintenance, or when
the heater is not in use.
• When installing infrared gas
heaters, follow the rules and
regulations for the installation
of similar equipment adopted in
your area.
• Replace gas cylinders in a
room with sufficient ventilation
away from the source of ignition
(candles, cigarettes and other
sources of ignition and flammable
substances).
• Use only special gas cylinders.
It is advisable to use only propane
gas.
• Sometimes a balloon may be
covered with frost - “freeze”. This
situation usually occurs when
there is not enough gas in the
cylinder. To reduce the likelihood
of the gas cylinder freezing effect,
it is recommended to work with
the minimum required gas flow
rate. There is a tacit rule that for
every kW should be 1 liter of gas,
therefore, 13 kW need 13 liters of
liquefied gas. For this equipment,
you must purchase a suitable
gas cylinder (27 l.).