Ballu BHG-10, Operation Manual

Page: 9 / 38

9
must be kept in working climatic conditions for
at least 2 hours.
2. Fasten the handle (for BHG models) to the
housing of heater with two screws M4x14.
3. Fix the stand to the heater housing with a self-
tapping screw 3.9x10 (for models BHG-10M,
BHG-20M).
4. Install the heater so that there is free access
to the controls and air access to the air intake
openings.
5. The mains to which the heater is connected
must have a ground line.
6. The heat generator must be grounded.
7. Connect the gas supply hose to the nipple
(5) on the heat generator. Make sure the gas
supply hose is not twisted, because this may
cause damage to the hose.
8. Connect the reducer coupling nut to the gas
cylinder.
ATTENTION!
• This connection has a left-hand
thread.
• Check all gas connections,
turn on the gas supply and
make sure that there are no
leaks (see the Maintenance
and Troubleshooting sections).
• Insert the power plug into the
mains.
Turning on
1. Operation of the fan heater should
be carried out in the range of operating
temperatures from - 10 to + 40 ° С.
2. Set the adjusting valve (3) to the minimum
power mode of heater (except for models
BHG -10, BHG -10M, BHG -20M.
3. Turn on the gas supply to the cylinder.
4. Turn on the switch (2). Make sure the fan
is working.
Maintenance
5. Press the gas valve button (4) and at
the same time repeatedly press the button
of the piezo igniter (1) until the flame lights
up. The gas valve button must be held for at
least 30 seconds, after which the burner will
light itself and the heat generator will start
to work.
6. For BHG-20, BHG-40, BHG-60, BHG-85
models, adjust the gas supply using the
adjustment knob (3) to the required power.
Disconnect
1. Shut off the gas supply to the cylinder.
2. After this, for five minutes, let the fan cool the
heat generator and then turn off the switch (2).
3. Remove the power plug from the mains.
4.If the gas heat generator is not used for a long
time, it must be disconnected from the mains and
from the gas cylinder.
Emergency shutdown
1. Shut off the gas supply to the cylinder.
2. Turn off the switch (2).
3. Unplug the power plug.
Ensure that the fault is repaired before use.
Maintenance
Remove the nozzle, check it and clean it by
blowing in the opposite direction of the gas flow.
For BHG-40, BHG-60, BHG-85
Remove the combustion chamber (make sure
that you unscrew all the screws, as well as all
the wires connecting the combustion chamber
with the body of the heat generator), remove
Scheme 1
Elektroda
Termo č l á nek
1,0 mm
3-5 mm
17,5 mm