HABFM-1401001
VERSION: 07_9
FLIGHT MANUAL
–
BALLONS CHAIZE
FLIGHT MANUAL
–
BALLONS CHAIZE
–
PAGE 58/64
Siège Social / Headquarters:
Chemin de Mirecouly - 07100 Annonay
| Atelier / Workshop:
188, avenue Ferdinand Janvier - 07100 Annonay - France
Atelier / Workshop - Tél. +33 (0)4 75 33 65 18 - Mobile - Tél. +33 (0)6 32 00 04 83 - [email protected] -
www.ballonschaize.com
SARL au capital de 20.00
0€
•
SIRET 790820062 0001
2 • TVA FR54 790820062 00012
VI.1
Envelope
Should you find a rip, ensure that it is within the tolerated damage limit shown in Section II.4. If it
exceeds the limit, refer to the maintenance manual.
No maintenance, unless there are rips. Should there be a rip under the first horizontal tape, the
user can repair it by stitching, or using adhesive tape. In all other cases, only the manufacturer is
qualified to carry out repairs (please see maintenance manual).
The suspension cables must be flexible, and must show no broken strands. Check condition of the
loop and the Velcro hook at the envelope apex.
VI.2
Lifting tapes or halyards
On models with tapes (straps) should any damage be found, please refer to the maintenance
manual.
On models fitted with halyards, these are found along 3 cm at the base of the Nomex. Check their
condition; in the event of damage, please consult the maintenance manual.
VI.3
Basket
•
Check condition of the suspension cables, especially those that pass through the basket
wickerwork.
•
Check condition of handles for passengers.
•
Check condition of the floorboard
:
cracks etc.
•
Check the general condition of the wickerwork.
•
If fitted, check the general condition of the restraint harness and ensure that it is properly
attached to the floor.
•
Ensure that the burner
’
s rods tubes are properly fixed and not damaged.
VI.4
Burner and power supply
They must be kept clean and in good condition. The controls must always be free and watertight.
Should they malfunction, do not hesitate to replace the defective part.
Bolted joints seal can be improved by using Teflon tape or similar.