888.496.5137
b
all
h
og
g
oals.com
PAGE 8
STEP 3 - POLE ASSEMBLY - LOWER ARM
With the jack ears still facing up, position the base plate of the pole inline with the anchor and up against the front set of anchor bolts.
Prop the pole up on a padded saw horse or a folding ladder as shown in Image 5 to complete the following.
Note:
It is very important that the installer understands the importance of the bushing assembly. A properly assembled bushing will
not only protect the painted parts during adjustment, but will provide a smooth and quiet operating system.
•
Attach the lower Y-arm to the pole as shown in Image 5 using one (#17) bolt, one (#9) stainless washer, two (#8) ABS washers, one
(#10) stainless steel tube and one (#11) white nylon tube per side of the lower arm.
Note:
Do not fully tighten the (#17) bolts at this time. These bolts will be tightened once the jack has been attached to the rear portion
of the arm in (Step 6).
Image 5
17
9
8
10
11
DETAIL #7
LOWER ARM TO POLE
8
11
10
8
9
17
#8 ABS WASHERS, ARE
TO BE PLACED
IN BETWEEN AS
SHOWN
NOTE: ATTACH THIS HOLE OF
THE Y- (LOWER) ARM
TO THE POLE AS SHOWN.
8
