Document ref.: IBVCP issue 1
Page 21 of 22
Control Panel Indicators and Controls
‘System OK’ LED
Illuminates when no faults are detected.
‘Common Fault’ LED
Will flash and a beeper will sound when a Fault is detected until “Fault
Accept” is pressed.
After a fault is accepted the beeper is silenced and the LED remains
illuminated until the fault is cleared.
‘Processor Fault’ LED
Will illuminate when a critical Processor fault has occurred.
‘Processor Restart’ LED
Will illuminate when the reset switch needs to be pressed.
‘Handset Fault’ LED
Will illuminate when a fault is detected with the handset or if it has
remained off hook for more than 45 Minutes
‘Mains On’ LED
Mains Healthy.
‘Battery High’ LED
Will illuminate when Batteries are overcharged.
‘Battery Low’ LED
Will illuminate when the Battery voltage is low.
‘Charger fault’ LED
Will illuminate if the batteries are unable to hold their charge or if they
are not fully charged after 24 Hours charging. Reset must be pressed
to clear a charger fault.
‘Fuse Fault’ LED
Will illuminate when any internal DC fuse fails.
Speech Volume LED’s
Will indicate speech level
Call Point Remote Unit Fault LED
Will flash yellow to indicate a fault with a remote Call Point Unit.
Call Point Remote Unit LED
Will flash when being called by a remote Call Point Remote Unit. It is
ON continuously when occupied
‘Reset’
Recessed switch that enables the Processors to be reset
‘Fault Accept’
Press to accept a fault once detected.
‘Lamp Test’
Press to check front panel indicators and buzzer operation.
All
Press to make an announcement to all the Call Point Remote Units
Speak
Press to make an announcement to the selected Call Point Remote
Unit. When released you will listen to the selected Call Point Remote
Unit.
