Care2
Installation Instructions
viii
Care2 issue 7
P
RECAUTIONS
AND
S
AFETY
I
NFORMATION
Environmental Conditions
Unless otherwise stated the following Technical Specifications
apply to this equipment:
This equipment must not be installed in an area that is subject to
a corrosive atmosphere, excessive moisture or may allow water or
other liquids to come into contact with the unit or its external
connections.
In the close proximity of some radio frequency transmitting
devices, the signal to noise ratio of this product may be reduced.
If this occurs, re-location of the equipment or the signal cables is
recommended.
General Safety Precautions
Personnel who install, maintain or repair this equipment must
read the safety information below before starting work.
AC Supply Voltage
230V ± 10% RMS 50Hz AC
DC Supply Voltage
21V to 27.6V (Nominal 24V) DC
Temperature (Operating & Storage) -5°C up to +40°C
Humidity Range / IP Rating
0% - 90% Non Condensing / IP30
C
AUTION
This product must only be disposed of in accordance with the
WEEE directive.
!
W
ARNING
This equipment is intended for continuous operation and as such
should be permanently connected to the mains supply.
This unit does not contain an external mains switch.
An all-pole Switch / Circuit Breaker with a separation of 3 mm in
each pole shall be incorporated in the electrical supply spur
feeding the unit, and this must be suitably marked to prevent
inadvertant or accidental useage.
