Baldor Nextmove ESB, Installation Manual, Page: 13 / 98

www.supportme.net
Basic Installation 3-1 MN1924
3.1 Introduction
You should read all the sections in Basic Installation .
It is important that the correct steps are followed when installing the NextMove ESB.
This section describes the mechanical installation of the NextMove ESB.
3.1.1 Location requirements
You must read and understand this section before beginning the installation .
CAUTION : To prevent equipment damage, be certain that input and output signals
are powered and referenced correctly.
CAUTION : To ensure reliable performance of this equipment be certain that all
signals to/from the NextMove ESB are shielded correctly.
CAUTION : Avoid locating the NextMove ESB immediately above or beside heat
generating equipment, or directly below water steam pipes.
CAUTION : Avoid locating the NextMove ESB in the vicinity of corrosive substances
or vapors, metal particles and dust.
The safe operation of this equipment depends upon its use in the appropriate environment.
The following points must be considered:
H
The NextMove ESB is designed to be mounted indoors, permanently fixed and located.
H
The NextMove ESB must be secured by the slots in the metal case.
H
The NextMove ESB must be installed in an ambient temperature of 0°C to 45°C (32°F to
113°F).
H
The NextMove ESB must be installed in relative humidity levels of less than 80% for
temperatures up to 31°C (87°F) decreasing linearly to 50% relative humidity at 45°C
(113°F), non-condensing.
H
The NextMove ESB must be installed where the pollution degree according to IEC664
shall not exceed 2.
H
There shall not be abnormal levels of nuclear radiation or X-rays.
3
Basic Installation
3