3
Specifications
Accuracy:
+ - 0.5% (of Reading)
Flow Range
:
0.26 – 8 gal/min
Maximum Operating Pressure:
1,500 PSI
Weight:
2.55 lbs
Inlet:
½” NPT
Outlet:
3/8” NPT (prior to 6/03)
3/8” NPS (after 6/03)
Operating Temperature:
32
0
– 122
0
F
Wetted Parts:
Aluminium, Acetal, Steel, Nitrile Rubber
Fluid Compatibility:
Engine Oil, Diesel Oil, Automatic Transmission Fluid,
Anti-freeze
Pressure Loss:
14.4PSI at 3.2 US gal/min with calibration fluid
(6 Centipoise viscosity) without extension.
Dimensions:
10 inch Long x 3.7 inch Wide, 4.33 inch High
(Dimensions without extension)
Assembly
Use Teflon
®
tape (or suitable thread sealant) when
connecting the control handle to the hose connection.
Outlet Extension
The outlet extension can be fitted either inline (forward) or
on the outlet port “pistol style” located under the meter.
Note:
The threaded plug removed from the outlet port on
the underside of the meter, is used to seal the outlet port
not in use.
Handle Operation
To latch the handle, press the lever, push the button and
then release the lever.
To release the latch, in manual or automatic mode, simply
press and release the lever.
When the control handle is in automatic mode the lever will
release automatically once the preset volume has been
dispensed.
WARNING
!
A manual tip cannot be used on P-Set control
handle. An auto tip must be used. Use of a
manual tip can result in overpressurization,
which can cause control handle to crack.
Meter Introduction
Operating mode description.
Sleep Mode:
To minimize battery consumption the meter will
revert to sleep mode if left idle for more than 2 minutes, and
will automatically “power up” when the
reset
button is pressed
or there is flow through the meter.
Manual Mode:
For manual operation. No status segments
displayed.
Auto Mode:
For auto shut off operation Batch Display flash
-
ing.
Reset Mode:
Displays the re-settable accumulative total.
Setting Mode:
Provides access to meter settings.
a) Change Preset volumes.
b) Unit settings. (gallons liters, etc.).
c) Options setting.
d) Calibration. (Factory setting).
Batch Display
Total / Status
Low Battery
Batch Display
Total / Status
Low Battery
