background image

2

General Description

This  manual  assists  you  in  operating  and 

maintaining your new P-SET Electronic Preset 

Control Handle. The information contained will 

help you ensure many years of dependable 

performance and trouble free operation.

Please take a few moments to read through 

this  manual  before  installing  and  operating 

your  new  control  handle.  If  you  experience 

problems with this product, refer to the trouble 

shooting sections of this manual. If you require 

further assistance please contact your local 

Balcrank

®

 distributor or Balcrank

®

 authorized 

service center.

General Safety

Thoroughly  read  and  understand  this  manual 

before  installing,  operating  or  servicing  the 

described products.

WARNING

!

 

DANGER: Not for use with fluids 

that have a flash point below  

 

100°F (38°C). Examples:  

gasoline,  alcohol.  Sparking  could  result  in  an 

explosion which could result in death.

 

Because this control handle can  

 

be incorporated into a pressurized  

 

systems, the following safety  

precautions should be observed.

Check equipment regularly and repair or 

replace worn and damaged parts.

Never alter or modify any parts of this control 

handle, doing so may cause damage to the 

control handle and/or personal injury.

Under no circumstances should the dispensing 

valve be aimed at any person at any time. 

Personal injury may result.

Release pressures built up in the system 

before any service or repair is begun. See the 

pressure relief procedure below.

Do not operate this control handle above the 

maximum operating pressure of 1500 psi.

Always read and follow the fluid manufacturer’s 

recommendations regarding the use of 

protective eye wear, clothing and respirators.

IMPORTANT

!

 

Pressure Relief Procedure:

Follow  this  procedure  whenever  you  shut  off 

the pump, when checking or servicing any part 

of the system and when installing, cleaning or 

changing any part of the system.

1)   Disconnect the air to the pump.

2)   Point dispensing valve away from

 

yourself and others.

3)   Open dispensing valve until

 

pressure is relieved.

WARNING

!

WARNING

!

A manual tip cannot be used on P-Set control 

handle. An auto tip must be used. Use of a 

manual tip can result in overpressurization, 

which can cause control handle to crack.

WARNING

!

Airborne particles and loud noise hazards.

Wear ear and eye protection.

Do not place your hand or fingers over the 

dispensing nozzle and/or aim the nozzle at a 

person at any time. Personal injury may result.

WARNING

!

Summary of Contents for 3331-014









Reviews: