8
1300 663 907
After Sales Support
www.balcobrands.com
Model number:
AU200016
Motorcycle Bluetooth Kit
Fitting the Bluetooth receiver to you helmet
1.
Open the TF card Slot as shown to the right
and insert the memory card (can support a
max of 64G TF card).
2.
Using the Allen key provided, loosen the
Headset Clip screws.
3.
Slide the Headset Clip onto the left side of
the helmet (when on your head). Take care
to place the inside of the Headset Clip under
the helmet padding.
4.
Adjust the clip until you find the best
location for your helmet. Ensure that the slots in the Headset Clip mount
are facing away from the helmet.
5.
Tighten the screws to hold the clip firmly
in place.
Note: Take care not to over tightening the screw as
this can break the clip.
6.
Slide the Bluetooth receiver down into the
slots on the headset clip. Make sure that this
is securely locked in.
7.
To attach the ear speaker & microphone
headset, test which part of the helmet will
be the best location by putting your helmet on and locating the place
closest to your ears. You will need to put the helmet on a few times to
find the optimum position to apply the pad. When the correct position is
found, remove
the adhesive
protective strip,
and apply to the
felt adhesive
earphone pad.
Setup
