32
SPECIFICATIONS
Remote Control Power
2 AA Batteries
IR Command Center Power
120 VAC
IR/Visual Equipment Range
*
Up to 30 Feet (7.62 m) ± 30°
Remote Control Dimensions (H x W x D)
9-2⁄16 x 2-10⁄16 x 1-3⁄16 in.
232 x 65 x 31 mm
Remote Control Weight (w/o Batteries)
8 oz (220 g)
NOTE: Specifications are typical. Individual units
may vary. Specifications are subject to change and
improvement without notice.
* Distance may vary.
TROUBLESHOOTING
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM: LED blinks when you press a key, but home
entertainment component does not respond.
SOLUTION: Make sure you are aiming the Dolphin at your
home entertainment component and that you
are within 15 feet of the component you are
trying to control.
PROBLEM: The Dolphin does not control home
entertainment components or commands are
not performing properly.
SOLUTION: Try all listed codes for the component brand
being set up. Make sure all components can
be operated with an infrared remote control.
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some
COMBOUNITSMAYREQUIREBOTHA46CODE
and a VCR code for full operation (see pages
8-15).
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume Lock
(see page 28).
PROBLEM: CH+ , CH– , and LAST do not work for your
RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the
original remote control will operate these
functions.
PROBLEM: Changing channels does not work properly.
3/,54)/.)FORIGINALREMOTECONTROLREQUIREDPRESSING
ENTER to change channels, press ENTER on
the Dolphin after entering a channel number.
PROBLEM: Tried “Search Method” and still could not find
a working code.
SOLUTION: Try the “Search Method” again after clearing
out the device key as follows: Press and
hold ENTER until red light blinks twice, then
release. Next enter 9 - 9 - 2. Then press and
release the device key to be cleared twice.
