22
PROGRAMMING
AUDIO CONTROL
Using the Dolphin’s RCVR mode, you can also
control an audio component, such as a stereo
receiver or a stereo amplifier.
Locate the brand name of your audio component
in one of accompanying code lists. Write it in the
appropriate space.
Stereo Receiver Brand:
or
Stereo Amplifier Brand:
The brands are listed in alphabetical order with
the most popular codes listed first. You will use
one of these codes to program the Dolphin to
operate your audio component:
1. Turn on the audio component.
2. On the Dolphin, press RCVR once. Press and
hold SETUP until the LED blinks twice, then
release SETUP.
3. Enter the four-digit code for your audio
component. If you perform this procedure
correctly, the LED will blink twice.
NOTE: If the LED did not blink twice after
entering the code’s last digit, repeat steps
2 through 3 and try entering the same
code again.
4. Aim the Dolphin at your audio component and
press POWER once. The unit should turn off.
If it does not respond, repeat steps 2-4, trying
each code listed for your brand until you find
one that works. If it still does not work, try
searching for the code (see Searching For Your
Code on page 25).
5. Write your audio component code in the boxes
below for future reference.
■ ■ ■ ■
NOTE: Remember to use the Dolphin to operate
your audio component, press RCVR first.
Setup Codes for
Stereo Receivers/Tuners:
ADC 0531
Aiwa
1243, 1405, 0158, 0189, 0121
Akai 1255
Alco 1390
Anam 1609,
1074
Anam 1609
