3
Μπλε
¡
Ουδέτερος αγωγός για συνδέσεις
τάσης δικτύου 220 - 240 V
¡
Φάση (εξωτερικός αγωγός) για
συνδέσεις τάσης δικτύου 400 V
Καφέ
Φάση (εξωτερικός αγωγός)
Τοποθέτηση της βάσης εστιών
Μην κολλήσετε τη συσκευή με σιλικόνη στον πάγκο
εργασίας.
Σημείωση:
Μην τσακίσετε ή μη μαγκώσετε το
καλώδιο σύνδεσης και κρατήστε το μακριά από
κοφτερές ακμές και καυτά μέρη.
¡
Στους τοποθετημένους από κάτω φούρνους,
οδηγήστε το καλώδιο στις πίσω γωνίες του
φούρνου προς το κουτί σύνδεσης.
¡
Στερεώστε τη συσκευή το λιγότερο με 4 κλιπ
στερέωσης.
Αφαίρεση της βάσης εστιών
1.
Θέστε τη συσκευή εκτός τάσης.
2.
Λύστε τα κλιπ στερέωσης.
3.
Σπρώξτε από κάτω τη βάση εστιών προς τα έξω.
en
Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡
Electrical connection must only be carried
out by a licensed expert. Incorrect con-
nection will invalidate the warranty.
¡
The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for any damage res-
ulting from incorrect installation.
Built-under
Do not install refrigerators, dishwashers, non-ventil-
ated ovens or washing machines underneath the ap-
pliance.
¡
If you fit a modular or compact dishwasher of the
same brand underneath the appliance, the work-
top must be at least 40 mm thick.
¡
If you fit an oven below the appliance, the worktop
must be at least 20 mm thick, in certain cases
even thicker. Observe the information in the oven
installation instructions.
Combination with other hobs
If the appliance is combined with a gas hob, the
worktop must be at least 20 mm thick. Follow the in-
structions in the installation instructions for the gas
hob.
Intermediate floor
If the underside of the hob can be touched, an inter-
mediate floor must be fitted.
¡
The minimum distance to the lowest point of the
hob is 10 mm.
Preparing the units
The worktop must be level, horizontal and stable.
¡
The fitted unit must be heat-resistant to at least
90 °C.
¡
Seal the cut surfaces with heat-resistant material.
Electrical connection
Observe the country-specific guidelines.
¡
In order to prevent dangerous situations, if the
power cord of this appliance is damaged, it must
be replaced by the manufacturer, the manufac-
turer's customer service or a similarly qualified
person.
¡
The appliance fulfils the requirements of protection
class I and must only be operated in conjunction
with an earth conductor.
¡
In the permanent electrical installation, a partition
must be provided in the phases in accordance
with the installation regulations.
¡
If
appears on the appliance's display, it has
not been connected correctly. Disconnect the ap-
pliance from the mains and check the connection.
¡
Ensure that there is sufficient fuse protection for
the household wiring.
¡
Observe the colour coding of the power cable.
Green and
yellow
Protective conductor
Blue
¡
Neutral for mains voltage con-
nections 220 - 240 V
¡
Phase (external conductor) for
mains voltage connections
400 V
Brown
Phase conductor (external con-
ductor)
Installing the hob
Do not use silicone to bond the appliance to the
worktop.
Note:
Do not kink or trap the connection cable, and
keep it away from sharp edges and hot parts.
¡
If the oven is a built-under type, route the cable
along the rear corners of the oven to the mains
socket.
¡
Use at least 4 retaining springs to secure the ap-
pliance.
Removing the hob
1.
Disconnect the appliance from the power supply.
2.
Loosen the retaining springs.
3.
Push out the hob from below.
es
Montaje seguro
Tener en cuenta estas indicaciones de se-
guridad al montar el aparato.
¡
La conexión eléctrica solo puede realizar-
la un técnico especialista autorizado. Si
se hace una conexión incorrecta, la ga-
rantía no tendrá validez.
¡
Solo una instalación profesional de con-
formidad con estas instrucciones de mon-
taje puede garantizar un uso seguro. El
montador será el responsable de los da-
ños causados por una instalación inco-
rrecta.
Montaje bajo encimera
No montar debajo neveras, lavavajillas, hornos sin
ventilación ni lavadoras.
¡
Si se utiliza un lavavajillas modular o compacto de
la misma marca bajo la encimera, el grosor de la
encimera debe ser de 40 mm como mínimo.
