37
Step 4:
With stand assembly
complete, rotate stand upside
down. Attach the leg levelers by
screwing them into the bottom of
the telescoping legs.
The telescoping legs can now be
adjusted to the desired height
requirement. This is done by
removing the
3
/
8
" bolts in each leg,
extending the leg and reinstalling
the bolts at the new hole location
(2 bolts per leg).
NOTE: If the cabinet is not in its
final room location you may want
to perform the leg adjustment after
assembling the cabinet to the stand
and moving it to the room.
Step 5:
Rotate the stand assembly
to the upright position so that the
leg levelers are now resting on the
floor.
Step 6:
Lift the cabinet high
enough to allow clearance for the
stand assembly to be positioned
under it.
Once the stand is positioned under
the cabinet, install (4) ¼” x 1-1/4"
carriage bolts into the key way
slots located under the cabinet in
each of the (4) corners. The cabinet
is now ready to be lowered onto
the stand. There are (4) holes on
the top of the stand which the bolts
must be guided through. Be careful
Telescoping leg
Leg leveler
3
/
8
” Hardware
[Items 4, 7 & 8]
¼” x 1-1/4” carriage bolt
Channel stand
Cabinet
Summary of Contents for SterilGARD SG303
Page 34: ...APPENDIX...
Page 36: ...34 SG303 Ladder Schematic...
