BAK Thermoplastic Welding Technology Ltd
2
SECURITY WARNING
Danger of life
when opening the tool as live components and connections are
exposed. Unplug the tool before opening it.
•
Danger of fire and explosion
in case of incorrect use of the welding machine
especially near combustible materials. Never use the welding machine in
hazardous or inflammable areas. Heat can reach combustible materials which
are hidden. Do not point the hot air stream onto the same position for a long
time.
Danger of burns!
Do not touch the hot air tool when it is still hot. Let the tool
cool down.
Connect the tool to a socket outlet with protective earth conductor. Any
interruption of the protective earth conductor within or outside the tool is
dangerous! Use only extension cables with a protective earth conductor!
VORSICHT
The voltage rating stated on the tool should correspond to the mains voltage.
Maintain the maximal allowed impedance
Z
max
= 0.301Ω + j 0,188Ω. Consult
your local electricity board if necessary.
For personal protection, we strongly recommend to connect the tool to a RCCB
(Residual Current Circuit Breaker) before using it on construction sites.
Do not leave the tool unobserved!!!
The tool must not be used by children or
people with limited physically, sensory or mental ability. Children must be
supervised to prevent that they play with the tool.
Protect the tool from damp and wet!
WARNING
•
If the supply cable gets damaged, it has to be replaced by the manufacturer, the service
centre or by a qualified person, to avoid danger.
•
The tool must not be used by personnel with just little experience and/or lacking
knowledge. Except when supervised by a qualified and for their safety responsible
person or when advised how to use the tool. Children must not use the tool.
•
Because of the enormous fire danger the operating personnel must be specially
advised and regularly instructed.
•
Fire can occur, if the machine is not used carefully.
•
A fire extinguisher must be within reach in the work area.
•
There is a great risk of fire, when the machine stops, because of any disturbance and
the hot air tool is running (max. temperature of the air flow 600°C). Therefore,
specific attention should be turned to the subsurface and the processing material.
