Baja BA400, Owner'S Manual

Page: 32 / 112

32
Baja™ Mobility BA400
EN
BATTERY TERMINAL CONNECTIONS
 Make certain that the terminal connections remain tight and uncorroded.
 The batteries must sit fl at in the battery wells.
 The battery terminals should face according to the battery wiring diagram. See III. “Batteries and Charging.”
WIRING HARNESSES
 Regularly check all wiring connections.
 Regularly check all wiring insulation, including the charger power cord, for wear or damage.
 Have your authorized dealer repair or replace any damaged connector, connection, or insulation that you fi nd
before using your vehicle again.
PROHIBITED! Even though the vehicle has passed the necessary testing requirements for ingress
of liquids, you should keep electrical connections away from sources of dampness, including
direct exposure to water or bodily fl uids and incontinence. Check electrical components
frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the vehicle. Always
grasp the connector itself when disconnecting the harness to prevent wire damage.
V I I I . C A R E A N D M A I N T E N A N C E
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or vehicle fi nishes.
WARNING! Never use any cleaning or disinfecting agent, solvent, lubricant, or any other product
on the brake pads, brake discs, transaxle, motor/gearbox of your mobility product. Doing so
may damage the components and/or cause them not to function properly. Property injury and/
or personal injury may result.
WARNING! Never hose off your vehicle or place it in direct contact with water. Your vehicle has a
painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
ELECTRONICS
(Joystick controller, enhanced displays, touch screens, remote controls, keyboards, cell
phones and tablets, as applicable)
 For electronics, remove visible contamination if present.
● Turn o ff product and disconnect batteries.
● Never spray any liquids directly into the product(s).
● Moisten a micro fi ber cloth with a mixture of 70% isopropyl alcohol/30% water solution. The cloth should
be damp, but not dripping or excessively wet. Dry surfaces thoroughly to avoid pooling of liquids and
prior to boxing.