Bailey pproach SE, Owner'S Manual

Page: 80 / 96

7-33
FITTED EQUIPMENT
• The yellow LED will indicate that the
water is in the heat-up phase. When
room temperature selected on the lower
panel is reached, the heater will switch
back to its lowest output and will heat the
water to 60
°
.
• Once the water temperature is reached
the heater will switch off and the yellow
LED will go out.
Supplying blown air heating without hot
water
Select gas, electrical or mixed operation
using the power selector switch.
• The yellow LED will illuminate to indicate
230 V operation. Move the rotary switch
on the top panel to the bottom setting
and the rotary switch to the desired
thermostat setting. The green LED will
illuminate to show that the unit is
working.
• The yellow LED will only illuminate if the
water temperature is below 5 degrees.
When the room temperature selected is
reached the heating will turn off.
• The warm air fan will continue to operate
at a slow speed until the temperature has
reached 40 degrees.
• If the boiler is filled it will be automatically
heated but the water temperature is
totally dependent on heat output and the
time taken to reach the desired heat.
Switching off
Switch the heater off by turning the rotary
switch to the position marked by a circle.
The green LED will go out.
Please note that if the green LED
blinks after switching off then the unit is
‘after running’ to reduce its
temperature. This will stop after a few
minutes and the green LED will go out.
Filling the Unit with Water
• Ensure that the cold water drain tap is
closed (the lever should be in the
horizontal position- please see draining
the water system) Please see page 6-4
• Turn on the hot tap in either the bathroom
or the kitchen. Position the tap in the
HOT position.
• Position the handles on the water pump
so that it is directed into the heater.
• Leave the tap open to let the air escape
from the water system while the tank is
filling. The heater is full once the water
flows from the tap. For more detailed
information on operating the Truma
Combi boiler please refer to TRUMA
appliance instructions that can be found
in your information wallet.
It is essential that you do not block/
obstruct or cover the flue outlet
from your Truma Combi Boiler.