27
27
Between two Cutters
The advantage of this setup is that you can make two
profile cuts in a single pass so it is frequently used when
both edges of the workpiece are to be shaped.
The disadvantage with this method, like the “Below the
Cutter” method, is that any accidental lifting of the
workpiece will cause gouging and ruin the workpiece.
(Fig. 26)
Fig. 26
Counterclock Wise Setup
With the cutter installed as shown, feed the workpiece
from right-to-left.
Clock Wise Setup
With the cutter installed as shown, feed the workpiece
from left-to-right.
Summary of Contents for SS-2421-V2
