Baileigh JP-1250-1.0, Operator'S Manual

Page: 25 / 64

22
22
1. Loosen the lock knob (J), slide the cutterhead guard (H) into a position to allow the fence to
move, then tighten the lock knob.
2. Loosen two fence assembly locking handles (E).
3. Move the entire fence assembly to the desired position; then re-tighten the handles (E).
4. Readjust and secure the cutterhead guard (H).
To tilt fence backward:
5. Loosen locking handles (F).
6. Tilt the fence back (A, C) to the desired angle up to 135 degrees. Or you can place your
beveled reference piece on the table and against the fence, adjusting the fence until the
angle of the fence matches the bevel of your gauge piece.
7. Tighten the locking handles (F).
8. Readjust and secure the cutterhead guard (H).
MACHINE ADJUSTMENT
Replacing or rotating knife inserts
The knife inserts on this jointer/planer are four-sided.
When dull, simply remove each insert, rotate it 90°
for a fresh edge, and re-install it.
1. Use the provided star point screwdriver to remove
the knife insert screw. See Figure 8. It is
advisable to rotate all inserts at the same time to
maintain consistent cutting. However, if one or
more knife inserts develops a nick, rotate only
those inserts affected.
Each knife insert has an etched reference mark to
keep track of the rotations.
An extra set of 10 knife inserts and knife insert
screws are included.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine. Blades are extremely sharp! Use caution when cleaning or changing.
Failure to comply may cause serious injury!
Figure 8