Baileigh JP-1250-1.0, Operator'S Manual

Page: 21 / 64

18
18
OPERATING SETUP
Jointer to Planer Setup
To change the machine configuration jointer to
planer (refer to Figure 2):
1. Disconnect and lockout power to the machine!
2. Position and secure the bridge guard/guide so
that it extends outward of the table.
3. Position the fence assembly so that it covers the
complete table.
4. Fully lower the planer table to allow clearance
for the dust chute to be rotated.
5. Release both cabinet table locks (A) by rotating
the handles toward the operator, then pulling
away from the machine.
6. Raise the table (C) using the handle (B).
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
Cutterhead knives are dangerously sharp. Use extreme caution when working around
them. Failure to comply may cause serious injury.
Figure 3
Figure 2