14
14
Securing the Base
The machine should be sited on a level, concrete floor. Provisions for securing it should be in
position prior to placing the machine. The accuracy of any machine depends on the precise
placement of it to the mounting surface.
Anchoring the Machine
Once positioned, anchor the machine to the floor, as shown in
the diagram. Use bolts and expansion plugs or sunken tie rods
that connect through and are sized for the holes in the base of
the stand.
This machine requires a solid floor such as concrete at a
minimum of 4” (102mm) thick. 6” (153mm) minimum is preferred.
ASSEMBLY AND SET UP
Mounting the Head
1. Secure the stand to the floor.
2. Mount the head assembly onto the stand with the
motor placed over the hinge side of the mounting
plate.
3. Secure the motor to the plate with four cap screws,
eight flat washers and four Nylock nuts.
WARNING:
Before operating; make sure it is firmly bolted to a table,
bench, or the floor. If it tips over on you, it could cause severe injury or death.
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
.31"
(7.87mm)
.50"
(12.7mm)