Baileigh Industrial IDX-10, Operator'S Manual

Page: 25 / 40

23
23
5. The gearbox is attached to the roller base by (2) ½-20 nylon lock nuts on the front and back
of the gearbox. Remove the locking nuts along with the spring washers (4) and the brass
washer (2). (Fig. 4) Remove the gearbox assembly from the roller base assembly. (Fig. 5)
6. Next, attach the sensor bracket (N) to the bottom of the
roller base using the (2) M6 flat head cap screws (M).
Attach the slotted sensor mount (Q) to the bottom of the
sensor bracket using the M6 SHCS (P) and the
coordinating flat washers (O). The magnetic sensor (D)
can then be attached to the slotted sensor mount using
the M3 SHCS and the coordinating lock washers (G). Be
sure that the sensor wire faces toward the rear of the
assembly, as seen in Fig. 6.
7. The magnetic strip (A & B) needs to be attached to the
index table. It is recommended, but not necessary, that the
index table be detached from the bender and from the
stand for this step as it is easier to accurately stick the
magnet to the side of the table. Saw bucks work nicely to
hold the table for the following steps.
8. With the index table detached from the bender, turn the table so the side rail of the table is
facing down and that the blank side of the table is facing up. Make sure this side of the table
is wiped clean of debris, grease, and oil. If the table is dirty the magnetic strip may not stick
to the table properly.
(Fig. 4) (Fig. 5)
(Fig. 6)