21
21
Automatic Drill Ejector
This machine is equipped with an automatic drill ejector. Between the nose of the quill and the
spindle housing there is a pivoting finger stop (N), which prevents the spindle from reaching its
top position. By swinging the finger stop out, the spindle reaches the upper position and pushes
the drill or tool out automatically. If the tool will not eject automatically due to excessive pressure
or heat, use the supplied manual tool ejector.
Caution:
Disconnect machine from the power
source.
MATERIAL SELECTION
When selecting materials keep these instructions in mind:
•
Material must be clean and dry. (without oil)
•
Material should have a smooth surface so it processes easily.
•
Dimensional properties of material must be consistent and not exceed the machine capacity
values.
•
Chemical structure of material must be consistent.
•
Buy certificated steel from the same vendor when possible.
CAUTION:
It must be determined by the customer that materials being
processed through the machine are NOT potentially hazardous to operator or
personnel working nearby.
Summary of Contents for DP-1500G
