Baileigh Industrial DP-1500G, Operator'S Manual, Page: 22 / 48

20
20
OPERATION
IMPORTANT: DO NOT change spindle RPM and or rotation direction until the
spindle has stopped completely. This will damage the gears, voiding warranty.
1. Secure the tooling in the chuck and close the swivel guard. Make sure the E-Stop button has
been reset by turning clockwise (cw).
2. Load and secure the piece part to the table.
3. Unlock the table, set to desired position, and re-lock. Adjust the lower half of the guard up or
down, as necessary.
4. Select and set the desired spindle speed. DO NOT change spindle RPM until the spindle has
stopped completely.
5. Set the Rotational Selector Switch to either CW or CCW as needed for the operation.
6. Turn the power ON-
OFF switch counterclockwise (ccw) to “START”. The spring loaded knob
automatically returns to center-run position. The spindle will now be running at the pre-
selected speed.
7. At this point, using the down-feed handle (V), you can drill manually.
IMPORTANT: DO NOT engage the power feed function when selecting CCW
spindle rotation. This will damage the gears, voiding warranty.
To use the power feed function:
8. Verify that the machine is running in the CW direction.
9. Point the arrow on the feed knob (O) to the desired feed rate.
Selection of feed rates can be made when the drill is running,
but not under load. The desired drilling depth is set by the
inch/mm scales on the front of the spindle housing.
10. To engage the power feed move the feed knob (O) to the right
and then down. When the desired depth is reached, the rocker
is tripped and the feed knob pops up. The spindle automatically
returns to the upper position while still rotating.
11. Repeat with above settings or make spindle speed and power feed changes as necessary.
CAUTION:
Always wear proper eye protection with side shields. Restrain
and contain long hair, loose or baggy clothing and remove jewelry to prevent
entanglement.
O
ON OFF
0 1
6
5
4
3
2
1
0 0
150
140
130
120
100
90
80
70
60
50
40
30
20
10
7
200
190
180
170
160
0.24
.009
0.33
.013
0.16
.006 0.10
.004
mm
inch