Baileigh Industrial DP-1400VS, Operator'S Manual

Page: 37 / 48

34
34
3. Wipe off any oil on the spring lock cover so it
does not slip in your fingers when you hold
the cover from spinning.
4. While holding the spring lock cover against
the side of the head stock so the cover stays
splined with the locking lug; loosen the lock
nut approximately
1⁄4"
turn.
5. Put on heavy leather gloves to protect your
hands from possible lacerations if the spring
uncoils during the next step.
6. Pull the cover outward just enough to
disengage the spring-cover lock slot from the
locking lug.
Note: It is important to keep a good
grip during this step. Letting go of the cover will
cause the spring to rapidly uncoil.
7. Rotate the cover counterclockwise to
increase spring tension, or let the cover
slowly unwind in the clockwise direction to
reduce spring tension.
8. Engage the next available spring-cover lock
slot with the locking lug and hold the spring
lock cover tightly against the side of the
headstock.
9. Snug the cover nut against the spring cover
just until the nut stops, and then back off the
nut approximately 1⁄3 turn, or just enough so
there is no binding at complete spindle travel.
10. Hold the cover nut and tighten the jam nut
against the cover nut.
19mm
Lock Nut
Spring Lock
Cover
Spring Cover
Lock Slot