Baileigh Industrial BSVT-18P, Operator'S Manual

Page: 29 / 56

26
26
8. Rotate the gib lock to lock the gib. The leadscrew will now be captured to allow for the
handwheel to crank clamping pressure.
9. Make sure the work piece is secure before continuing. The work piece can be undamped by
turning the hand wheel counterclockwise.
•
The lead screw with hand wheel may be attached to either vise plate. It is recommended that
the angled edge of the plate be used when performing miter cuts and the vertical edge used
when making vertical cuts in order to clamp the work piece as close to the blade as possible.
•
The half nut assembly can be used in different mounting holes according to the cutting angle
of the work piece.
•
When the width of the work piece less than 50 mm, the rear vise plate should be move
forward to securely clamp the work piece.