13
13
5. Lift up on the roll head to insert M12 x 70 hex head bolt (A), M12 washer (B) and spacer (C)
into the front mounting hole.
6. ON the opposite side, install a spacer washer (C) between the channel and the head and
then install the M12 washer (B) and M12 nut (D).
7. Tighten securely.
8. Remove the M10 x 40 socket head bolt (E) and clamping block
from the material back stop and insert the back stop into the
throat of the roller head.
9. Position the material stop where desired and snug the M10 x 40
socket head bolt (E) to hold the stop in position. Fine tune the
material stop by loosening the T-handle bolt, positioning the
material stop, and tightening the T-handle bolt.
10. Plug into the 110V volt power and test the operation.
E
B
A
C
C
D
B
Summary of Contents for BR-18M-24
Page 21: ...19 19 PARTS DIAGRAM A...
Page 22: ...20 20 PARTS DIAGRAM B...
