Baileigh Industrial BB-9616M, Operator'S Manual

Page: 27 / 40

25
25
Rolling an Edge
Use a piece of solid steel round or a pipe to
accomplish this.
1. Position the clamping bar and the round bar as
shown in (fig. 14) to ensure that the piece part is
positioned correctly. Energize the electromagnet.
2. Raise the bending leaf to make the initial bend.
3. Release the electromagnet and rotate the piece part
down to the horizontal position.
4. Continue the above procedure until you are satisfied
with the result.
Making a Box with Clamping Bars
1. Using a long clamp bar, initiate the first two bends.
2. Choose and insert one or more of the short clamp bars as shown in (fig. 16) below for the
opposite bends. (This method allows for deep depth boxes.)
3. Clamping bars can be laid side by side or pinned together for repeat bending of multiple
units.
figure 14
figure 15
figure 16